Can you identify this quadcopter?

I

inou

New Member
Hi Guys,

I got this Quadcopter not sure about the brand or anything, just came in a box. Here is the image:
3JO5YTgztyE1


1. I charged the quadcopter. Its LEDs get flashing.
2. I pressed ON on the controller.
3. I flicked the left controller up then down again, the controller beeped and the LEDs on the quadcopter became steady ON no more flashing.

According to the manual, all I had to do was pull the left lever up and the drone would take off, but the motors won't even rotate. Not any of them, all 4 motors are OFF. The manual said this is a safety feature, that the drone will not give power to the motors if it is not in communications with the controller. Fair enough, but I think the communications is working both ways. I read several posts about this problem but all were previously working models that hit a wall, their blades rotate but no lift off. In my case the blades are not even rotating, I pressed all the buttons, what else can i do? :)
 

Attachments

  • Quadcopter.jpg
    Quadcopter.jpg
    331.9 KB · Views: 10
Hi GJH, no i looked everywhere, no numbers at the bottom of the remote nor at the bottom of the drone itself. I took it outdoors to see if the issue was 'no GPS signal to lock in a home location to return to', as was suggested in one of the articles I read, but still no movement of any kind in the rotors. I tried to press the buttons in combination, also nothing.
 
inou said:
Hi GJH, no i looked everywhere, no numbers at the bottom of the remote nor at the bottom of the drone itself. I took it outdoors to see if the issue was 'no GPS signal to lock in a home location to return to', as was suggested in one of the articles I read, but still no movement of any kind in the rotors. I tried to press the buttons in combination, also nothing.
Click to expand...
Do you have a multimeter or a was to test that the battery really charged? Some won't arm on a low battery. Also are you setting it on the ground when you do the up and then down with the sticks?
 
Hi, GJH i tried on the ground and on the desk. I do have a voltmeter, what voltage am i supposed to read?
 
inou said:
Hi, GJH i tried on the ground and on the desk. I do have a voltmeter, what voltage am i supposed to read?
Click to expand...
Should be around 4v per cell. Probably a 1S battery so 4-ish but no lower than 3.7v. If the battery were older or over discharged it could easily be dropping really fast.
 
You must log in or register to reply here.
Back
Top