Can someone please give me some feedback on my first build?

Charlos_FPV

Charlos_FPV

New Member
Frame: QAV-R
Motors: Lumenier 2350 KV
ESC's: Lumenier 30A BLheli_S Opto 2-4s
Flight Controller: F4 V5 Pro AIO
FPV CAM: Run Cam Split
 
All that should work nicely.
Just check it with a multimeter before you plug a lipo into it. Shame to waste all that kit. Maybe should have started with cheaper just as reliable parts.
But you will have a blast on 4s.
 
Charlos_FPV said:
Frame: QAV-R
Motors: Lumenier 2350 KV
ESC's: Lumenier 30A BLheli_S Opto 2-4s
Flight Controller: F4 V5 Pro AIO
FPV CAM: Run Cam Split
Click to expand...

If you have OPTO ESCs you'll need a BEC to power your 5v electronics unless your flight controller has that ability.
 
The fcb is an all in one. So it runs right off the lipo. Just connect esc's, motors, frame antenna & good to go. Good idea but if something breaks,although you could add extras it would be dead weight.
The most I would go for is a fcb/pdb.
Like the Neo which also has a separate
OSD/Vtx. Combined with a 4in1 esc if your into that. Gives a 3 board stack.
I would rather stay with separate esc's on the arm's & have a 2 stack with 15 or 20mm standoffs to keep the CG tight.
 
You must log in or register to reply here.
Back
Top