Can I trim off the outer edge of my board camera?

tylorwashere

tylorwashere

Well-Known Member
One of my friends seems to think that the outer part Is there as a form of rf protection, but to me it looks like it's meant to give more options for mounting, thoughts? 12961139_1144124202278631_1517658059394291080_o-240x427.jpg
 
I've had a couple boards like this. I just dremeled off the outer part so that it would fit my 250. However they weren't exactly the same. You shouldn't have a problem however please note this advice comes with no guarantee:confused:
 
RENOV8R said:
I've had a couple boards like this. I just dremeled off the outer part so that it would fit my 250. However they weren't exactly the same. You shouldn't have a problem however please note this advice comes with no guarantee:confused:
Click to expand...
Hahaha, same for mine, should be fine, but you have no guarantees.


I've cut down a Eachine FPV camera and it still works, that is only of a little comfort I suppose.

SKU200088-12.jpg
 
I bought one of these - no trimming necessary - the freakin' thing is TINY! (ordered Feb 27th, finally delivered just yesterday!) I *wish* it was slightly larger - it would then fit into the mount I picked up at the same time… as it is, the mount is ginormous compared to this itty bitty camera!
 
WLDOR said:
I bought one of these - no trimming necessary - the freakin' thing is TINY! (ordered Feb 27th, finally delivered just yesterday!) I *wish* it was slightly larger - it would then fit into the mount I picked up at the same time… as it is, the mount is ginormous compared to this itty bitty camera!
Click to expand...
You said tiny? Take a look at this one too hahaha. Lower power so not very suitable for bigger quads, but perfect for those symas

http://store.flitetest.com/hyperion-mini-600-tvl-camera-w-built-in-5-8ghz-25mw-vtx/
 
You must log in or register to reply here.
Back
Top