Dural_
Member
Hey pilots and makers,
I have just started making my third Quad this morning, It's brushed, and way small, More like a Microcopter, I 3D Printed the frame (Like the second one), and I'm excited about making this one because I'll be able to fly it Indoor, and that it ends up way cheaper than the others (the motors are brushed, and no ESC). The only bummer is that I'll have to pay a minimum of 60$ for a Quad that won't even cost me 30$. Here are some pictures.
My Copters, The largest was the first, and the tiniest is the latest. All Arduino powered
And the tiny one, The print was not a good one but wasn't bad enough for a reprint xD
I have just started making my third Quad this morning, It's brushed, and way small, More like a Microcopter, I 3D Printed the frame (Like the second one), and I'm excited about making this one because I'll be able to fly it Indoor, and that it ends up way cheaper than the others (the motors are brushed, and no ESC). The only bummer is that I'll have to pay a minimum of 60$ for a Quad that won't even cost me 30$. Here are some pictures.
My Copters, The largest was the first, and the tiniest is the latest. All Arduino powered
And the tiny one, The print was not a good one but wasn't bad enough for a reprint xD