Bugs 3 issue

F

Földing Benjamin

Member
Hi guys! I've Got an MJX bugs3. IT flew nicely at first but now it got a bit wobbly or or how to say it... When i try to just hover with it, it's going up and down and if I can make it stay in one place it kinda Shakes. I found a video with similar problem:
Some people said they swapped the main board or or so called receiver but it stood the same. Could you guys give me advices?

Sorry for my broken english, and If it's a bad question :)
 
F

Földing Benjamin

Member
It's Done. On the quad and the transmitter too. It's kinda horizontal shake. Like one of the motors works too much or not enough and IT jumps a bit. And it's much harder to control.

On the video it's near 12 secs when wou see It.

It became realy hard to hoover, and IT changes the direction of the front ( so yaws )
 
Last edited:
RENOV8R

RENOV8R

Well-Known Member
Take the prop off and inspect the motor. Sometimes even a piece of thread or other debris wrapped around the shaft can cause this issue
 
RENOV8R

RENOV8R

Well-Known Member
I wouldn't, a visual inspection should be enough. Does this motor spin by hand as freely as the others?
 
F

Földing Benjamin

Member
It's brushless (if that matters) all of motors can can be spinned by hand with the Same easiness I think. And i dont know which motor malfunctions...
 
GJH105775

GJH105775

Off and on
Moderator
It might be propwash. It looks good. Could probably use some PID tuning, but from the video it doesn't look bad. Have any first person video or blackbox data?
 
You must log in or register to reply here.
Top