BLheli esc’s

[mozquito1]

I wouldn't buy R-line unless I was racing or really showing off. I killed so many graphene packs, just out flying & messing around. there is cheaper options.
R-line are good, I have one. But it only gets used when I build a kwad for someone. To say this is yours this is what it can do. But that's my battery.

 

[2005h4]

I'm thinking this one. Acehe 4S 14.8V 1300mAh 75C High Rated Lipo Battery. $21 at the LHS.

 

[2005h4]

This might be silly question but I had to ask. The control board doesn’t need to be in the center right? It can be front or back. After seen you guys quads, I decided to redo mine.

 

[mozquito1]

This might be silly question but I had to ask. The control board doesn’t need to be in the center right? It can be front or back. After seen you guys quads, I decided to redo mine.

It most certainly does have to be in the centre. The gyro is centre of gravity.
Face it any way you like but it got to be centered.

 

[RENOV8R]

It most certainly does have to be in the centre. The gyro is centre of gravity.
Face it any way you like but it got to be centered.

Not true

 

[mozquito1]

It will keep level but you try doing a flip or roll. That's where your problems start. The chip is the axis.
I have tried it, a while ago & the CG was mad.

 

[mozquito1]

Hey go for it but you will spend a few hours getting used to it.
Post a pic of your build.

 

[2005h4]

Finally got my 3d props and went for test flight. I was able to filps, inverted, smooth tic tocs like cp heli. But another serious problem happened.

All 3 batteries completely puffed. After 2 mins almost no thrust. And battery got so hot and puffed I thought its going to explode. I was using 30c 11.1v 2200 batteries. They were all slightly puffed before though......

I will pick up some 75c 14.8v 1300mah batteries tomorrow.

 

[2005h4]

Finalized my quad...3d orange props and adehe 4s 75c 1300mah battery. Scary power ....