Binding a Spektrum dx6i to a blade - Horizon Hobby Inductrix FPV BL BNF Basic..

M

mrik

New Member
Hi,,
I just been given one of these and bought the transmitter to complete,,
I did read and watch few videos about binding similar model to the dx6i but mine does not work.
-" airplane + accro + model name... connect battery, flip the quad, all leds flash dast,,
It should have the 4x leds light solid when it is bind but the white ones still flash.
I tried to bind with other inductrix - blade and it is working fine,,
Anyone has an idea? BLH8850_A0_2XLGH540.jpg
 
Could just be the receiver on it is dead and could be replaced. If it has a USB port can try hooking it up to a computer and assuming it runs betaflight can use the configurator to see if the FC seems to be working as expected and ESCs/motors are good in which case if the RX is dead you could most likely tack one on (would just need to find where on the flight controller to tack in the control signal and configure things).
 
Back
Top