Hi experts!
I had to conenct a new PDB to my FCP, but it seem this damn v2 version of PDB doeen't have a flat wire connector :-/ ...like the old one did.
With this I've tried to figure out how to connect this up, wire by wire, from the included JST-SU conenctor with wires.
I need someone that knows this stuff to have a look and see if I've conencted things correctly.
...and one specific thing. Do I need to connect these voltage selector pads on the PDF, if so, how?
My battery is a 14.8V 1800mAh 75C 4S Lipo Battery.
I've conencted it up to INav. Most things seem ok, but of the motors (Motor number 3) are not spinning when armed and giving some throttle. No. 3 dosen't twich at start-up, so I suspect an ESC issue on that one.
Any and all help will be much appreciated!
Br
I had to conenct a new PDB to my FCP, but it seem this damn v2 version of PDB doeen't have a flat wire connector :-/ ...like the old one did.
With this I've tried to figure out how to connect this up, wire by wire, from the included JST-SU conenctor with wires.
I need someone that knows this stuff to have a look and see if I've conencted things correctly.
...and one specific thing. Do I need to connect these voltage selector pads on the PDF, if so, how?
My battery is a 14.8V 1800mAh 75C 4S Lipo Battery.
I've conencted it up to INav. Most things seem ok, but of the motors (Motor number 3) are not spinning when armed and giving some throttle. No. 3 dosen't twich at start-up, so I suspect an ESC issue on that one.
Any and all help will be much appreciated!
Br
Attachments
Last edited: