4 in 1 ESC calibration problem.

M

MikeFletch

Member
Sorry to post in such a short time but these ESCs are quite irritating. To calibrate these ESCs I first used CleanFlight, setting throttle to max, hear the tune, then to min throttle. Using the software, I increase throttle to see if they're calibrated properly, I'm sure they are. So I plug the receiver into the FC then plug the battery in, hear the start up jingle and then a beep. One of the ESCs have somehow uncalibrated itself and won't start up at all with the other motor which start up fine. I've also tried calibration by receiver and both ahve the same outcome. Please help, Mike :)
 
Hi thanks so much for the response, looking on Cleanflight, i can see that there are multiple DSHOTs to choose from, i was using PWM before as that is what my receiver uses. How do i know which one to choose from, there is 150, 300, 600 and 1200. Thanks :)
 
Most 4 in 1 ESCs are fine on 600 unless they're 32 bit, then you can go with 1200. It doesn't matter if you're using PWM, PPM or sBus for your receiver, it doesn't influence DShot, which is the signal between the flight controller and the ESCs
 
I set up the board with the DSHOT600 ESC protocol but when I start the quad up the motors still beep as if they need to be calibrated. Pls help
 
Multushot & is faster than dshot & better IMO. Esc calibration takes 2 seconds on my phone. Are all throttle ranges the same on all esc's in blheli.
 
thanks for the reply mozquito. im not sure how to calibrate Multishots and DSHOT will not work - the motors just carry on beeping. Not sure how to use BLHeli either so im a bit stuck here. Thanks for your help though :)
 
In blheli, with props off & battery plugged in. Click connect then Read setup.
4 esc cards should come up. Then click flash all. 2 boxes @ top left will show up.
Don't change the top one which is normally CH-15 or something.
Just the version under it, then a list of protocols will show up. Now don't quote me on this but I think anything above 16.43 is dshot. It will say next to it anyway. I may need to update my blheli.
 
So using the BLHeli Configurator, ive read all four of my ESCs, then clicked flash all, at this point, a tab opens saying target. I know ive got Afro 20A but do not know what mode or version to flash to the ESCs.
 
You only want to update, not change version. Fast start or crazy fast start or imperial march are multushot. But there is newer versions.
If you pick that top box & change it, well unless you remember what version & have it in the list. You may have trouble finding it again.
 
Back
Top