Yes i reflashed it a lot of times...
The reveiver is connected to my transmitter.
Do i have to remove the old firmware before putting on a new one? :eek:
If yes how do i do that?
Well i assume it did since smoke came out of it and it stopped working :/
but i got a new one still doesnt work so i tryed to flash the board again but i get an error
its says : avrdude verification error first mismatch at byte 0X0350
So i build my tricopter http://www.instructables.com/id/Inexpensive-Wooden-Tri-copter/
And i connected everything flashed the board connect the battery attempted to lif of aaaaaaannnnddd..... nothing...
I ordered it :)
Can i use this avr programmer?
www.let-elektronik.dk/pololu-usb-avr-programmer.html
Because the other one turned out to cost 45 $ in shipping
I got the receiver out of the helicopter and it looks like it will work
And the cable well guess i forgot to remove it
And yes i will build the frame
And yes i ordered the motors
Oh yeah and i added a bit of 4mm heat shrink
I got the receiver out of the helicopter
And it should work but the cables i use from the control board to the receiver do i get them with the control board or do i have to order them?
I have this little charger from the helicopter too can i use it to charge the battery for the tricopter?
It says:
2&3 cell (7.4V & 11.1V) Li-ion Polymer
BALANCE CHARGER EK2-0851