Connection receiver 9x8cv2 and esc to arduino UNO

N

NeonSerg

New Member
Hi,i'm building my first quadcopter with arduino UNO, GY521 and a 9x8cv2 receiver like in this picture
http://www.mediafire.com/view/2ff69s7des7d6vs/spiegazione_quadricottero.png

But after connecting all it don't work! Motors do 3 beep and then 1 beep every second but they don't work. I think the problem is around the connections to the receiver, i'm following this datasheet:

CH1: PITCH
CH2: ROLL
CH3: THROTTLE
CH4: YAW
CH7: MODE

Can someone posts the correct datasheet for this receiver? or maybe tell me about the other possible problems that cause the not working of my quadcopter.

thank you guys,sorry for my english :)

Picture of my quadcopter connections:
https://drive.google.com/file/d/0B-ZJ-O4Z8d16bHhvMGdPeWdQWkU/view?usp=sharing
 
Last edited:
Sorry I dont do a lot on that board if you go to the link I left you they have a members page where you find more help , let me know how you get on
 
Back
Top