Flip32 Omnibus - Betaflight 3.0

J

JMF

New Member
I'm a newbie to quads and I just flashed my Flip32 Omnibus now it doesn't show the barometer sensor any ideas or help would be appreciated.
 
Did you flash it with Betaflight? When you say "it doesn't show" do you just mean the tab isn't lit up? Power up and check the baro graph in your software and see if it shows any readings, blow on the sensor and see if the graph spikes. It's possible that it's working and just not showing. Also, I'm pretty sure that you have to be in alt hold mode for the baro to be activated. Plus I recall reading somewhere that the #970 baro sensor which I think is the one that the flip32 uses is not supported in Cleanflight, only Betaflight.
 
RENOV8R said:
Did you flash it with Betaflight? When you say "it doesn't show" do you just mean the tab isn't lit up? Power up and check the baro graph in your software and see if it shows any readings, blow on the sensor and see if the graph spikes. It's possible that it's working and just not showing. Also, I'm pretty sure that you have to be in alt hold mode for the baro to be activated. Plus I recall reading somewhere that the #970 baro sensor which I think is the one that the flip32 uses is not supported in Cleanflight, only Betaflight.
Click to expand...
Thanks for the reply, looks like I had it disabled in the configuration, told you I was a newb, thanks again...
 
Back
Top