ZMR250 FRSKY x4r not working

R

Rob Reeves

Member
My issue is the naze32 rev5 is not sending signal to the rec'r. The receiver is binded, and telemetry is working. I have power to it. I'm using Base Flight.

i hooked up a non-Sbus reciever and still no control between the Radio and the quad. Same issue with Cleanflight.

I am able to test the motors when the USB is plugged in.

I did the hack to not have to flip the signal. I can not find a good youtube video, as my thought is it something between baseflight and the NAZE

stumped
 
R

Rob Reeves

Member
Yes first quad first build, no the channels do not move in either base flight or clean flight any guidance is appreciated
 
ringolong

ringolong

Well-Known Member
Do you have sbus selected as the receiver mode?

Skärmklipp-2015-03-31-05.04.241.png
 
R

Rob Reeves

Member
Pics of my quad set up
 

Attachments

  • IMG_2721.JPG
    IMG_2721.JPG
    748.6 KB · Views: 3
  • IMG_2722.JPG
    IMG_2722.JPG
    601.5 KB · Views: 3
  • IMG_2723.JPG
    IMG_2723.JPG
    563.7 KB · Views: 3
  • IMG_2724.JPG
    IMG_2724.JPG
    697.3 KB · Views: 3
R

Rob Reeves

Member
I'm not 100% sure but in cleanflight CLI, it would not except PPM command or SBUS, and only RX Parallel receiver could be selected. I think it must be the Naze. So I used my V8r7-II, and was able to power up the motors. But when at full throttle it would not lift, and eventually tilted and broke the props. and the prop nut was spun off, so I think i had the props wrong. but I will recheck the motor to ensure they are spinning the correct directions. I have another Naze Rev6 that I might swap out with the Rev5 from MultiRC im currently using.
 
You must log in or register to reply here.
Top