would this build be atleast decent for 200€?

[Lpgfinmarkus]

• XBIRD 250 mini carbon fiber frame
• CC3D flight control system
• 4 x iPower MT1806 2300KV brushless motors
• 4 x Ipeaka Sk10A
• 4 x 5030 plastic propellers
• 1300mah 3s battery

 

[GJH105775]

Welcome to the forums. For a start you need at least 20A ESCs to run this. This is because your motors are 14amp and you need at least 5A of leeway. Unless you want to solder direct you will want to get some bullet connectors (at least 12 and they usually come in packs of 10) . To make connections easier you'll want a power distribution board or cable, with a compatible battery connector (deans, XT60, EC3).

 

[Lpgfinmarkus]

Thanks. A local store was selling these parts as a kit so i tought to ask if its worth it.

 

[GJH105775]

You get to save a good bit of money for shipping and a load of time. You might ask them about the 10A ESCs and 15A motors being in the same kit. They may give you some 20A as a replacement.

 

[Lpgfinmarkus]

They probably wont. Its quite a big store that isn't really specialized in quads. I might just buy the kit and ESCs seperate. (F my english btw )

 

[GJH105775]

If you have an amp draw meter you may test the amp draw. But the ESCs are not going to be very good anyways, may be better off just to replace them with a 20a.