I was well within operating voltage, and I had used it multiple times before, although just to tset it and show people my goggles. About 5 minutes into my first fpv flight (which was amazing btw), I brought my quad down and was looking at something when I noticed it started to smoke. There was no throttle or anything being applied, it was just sitting there. Do you think this is just a freak occurrence or if I replace it will it happen again
LINK it.
Well it needs a new VTX.
If it has correct power and a good ground, not shorted and antenna is making good connection, not much else is left.
So basically it needs 7V to run, let's call it 8V. An ideal source would be a 2S lipo. So if you are running it with a 3S lipo the difference between the pack voltage and what it needs is simply being burned off, hence the heat.
I understand and dont disagree with the laws of electicity. If its designed to handle up to 16vts and it burnt up then its defective, right? Thats all im saying. I think I have a 5-12vt vtx that is still running strong on 12.6vts. Cameras on the other hand, ive been through 3 of them. After crashing.
It would have to be very poor though. Were you using a 2.4 antenna?Well it needs a new VTX.
I was reading somewhere (IBcrazy antenna guy) that if you have a poorly tuned antenna it can cause the vtx to get really hot. Maybe look into that as a possibility.
Was your transmitter also reversed polarity SMA? If you try to put a RP-SMA anteana on an SMA connector you get no connection even though it fits perfect
I thought the rp referred to the pin being either male or female. I was getting clear video at about 50-60 yards so I'm assuming I had the right antenna lol
Ahh, so I was right for the wrong reasons? Lol
RP actually stands for reversed polarity, but you were perhaps correct physically.
