Trimming the sky quad pro v2

Rowlie

Rowlie

New Member
Hey guys.. I'm a right noob at this and got this cheaper drone for xmas from the wife.. did two test flights and thought I had picked up the controls when yesterday I had a horrendous crash! Now when I take off it automatically flies backwards and there's no amount of manual correcting that can make it stay straight! Is there a way to trim this out, like you would an RC car? Thanks in advance Rowlie.
 
On the TX there is a red oblong switch/button on the right hand side next to the control lever. Press the button,this puts it in trim mode, move the lever forward to trim forward, every time you push the lever forward it puts trim on. Do this for forward, reverse,left or right. When you have finished trimming press the red button to switch trim off.
 
Rowlie said:
Hey guys.. I'm a right noob at this and got this cheaper drone for xmas from the wife.. did two test flights and thought I had picked up the controls when yesterday I had a horrendous crash! Now when I take off it automatically flies backwards and there's no amount of manual correcting that can make it stay straight! Is there a way to trim this out, like you would an RC car? Thanks in advance Rowlie.
Click to expand...
 
Take it back, tell them it's crap! Loads of people have bought these for Christmas thinking it was a good drone, it's an expensive flying peice of crap
 
There should be some way (involving stick placement) to calibrate it. Check the manual.
 
Rowlie said:
Hey guys.. I'm a right noob at this and got this cheaper drone for xmas from the wife.. did two test flights and thought I had picked up the controls when yesterday I had a horrendous crash! Now when I take off it automatically flies backwards and there's no amount of manual correcting that can make it stay straight! Is there a way to trim this out, like you would an RC car? Thanks in advance Rowlie.
Click to expand...
you may need to calibrate it switch your drone on then your reciever
next sync your drone to the controller by pushing the left stick forward
then back once youv don't that rorate the right stick anty clockwise the lites will flash on
the drone when stoped flashing your drone will be calibrated .you might have to trim each blade after
calibrating
 
You must log in or register to reply here.
Back
Top