Basically iv built my 25o quad using a cc3d openflight control board with a frsky d4r ii rx and iv got the green light stating it is bound and set up in ppm mode.
Iv done the installation for the quad and everything went fine,the motors are all working and spinning in the correct position but when I come to the transmitter wizard it doesn't move the sticks like instructed, iv read a couple of threads that said to try a few things and at 1 point it would move the first 2 stick positions in the wizard but it stops there :/
Any help would be much lay apreeciated
Iv done the installation for the quad and everything went fine,the motors are all working and spinning in the correct position but when I come to the transmitter wizard it doesn't move the sticks like instructed, iv read a couple of threads that said to try a few things and at 1 point it would move the first 2 stick positions in the wizard but it stops there :/
Any help would be much lay apreeciated