Tmotor f7 FC,

[pumpkin head]

Hello everyone,I need help connecting my fs-ia6B receiver to a Tmotor f7 FC,where does the signal wire go?

 

[wafflejock]

They are expecting where it shows on the right for receiver input but also note there says any UART can support being the "receiver", the important thing basically is to select the corresponding "serial RX" toggle on the ports tab in betaflight, so if you use R1/T1 use Serial 1 etc., then check in the receivers tab to see if the receiver is sending data to the FC. Once the transmitter and receiver are bound and protocol set from transmitter to use s.bus I think it should work okay?

 

[pumpkin head]

Thanks you so much,it worked ,IAM now working on arming haha

 

[pumpkin head]

Actually I used uart 6

Thanks you so much,it worked ,IAM now working on arming haha