Throttle issue once stick is moved up motors rpm keeps climbing. loss of control

[Smooth99]

Hi there, bought a new iflight nazgul V5 5" BNF quad in Feb 2022.

Issue: When I push throttle up just a bit maybe 25% position the motors keep ramping up up up to max. Disarm drops to minimum once again, throttle up same issue.

What works, everything else is perfect. Pitch, Roll, Yah are perfect and react in Betaflight config 10.7.2 like they should. So best I can tell everything on the Quad works and responds perfectly except the throttle when moved forward just keeps going up in rpm.

What I have tried. Flash firmware on FC ( Iflight Blitz F722 ) & TBS crossfire micro, TX12 Radio Master, DJI V2 Goggles all to the latest firmware as well. No change

What else. Check radio for any settings that could cause this. Test in Betaflight under receiver tab that the sticks work to correct movements and all is perfect.. Also in the motors tab I can adjust master slider and all 4 motors come up at the same time so that's perfect. But when stick is used all of the 4 motors come up different values. if I move to 10% position and down they lower, if I go up to 20% approx they will slowly ramp up different values till 1 or 2 reach max rpm value and going throttle down at this point does not help.

So this is a new quad never flown and I am a new pilot. But the one thing that I have setup up differently is mode 3. Basic moving gimble over for throttle on the right and detach spring. So I am confused on the issue. You see the throttle, yah, pitch and ele all display the slider bar perfectly when they are moved in Betaflight

Any help with this is so appreciated.

 

[Launchpad]

You didn't clarify, but I'm guessing you have it on the bench with props off.
It's a common question here. Basically, your quad doesn't know why it's not moving.
If everything looks good in Betaflight, and the motors are going the right way, put some props on it and send it.

 

[Smooth99]

Yeah you're 100% right that's exactly what I did and it turns out that everything is working just fine. I thought that the master slider which slides all four motors up at the same time would be the same as lifting the stick for throttle and four motors coming up evenly at the same time. But I realize that the flight controller is adjusting itself automatically therefore motors coming up at different levels at the same time is normal. Thank you so much for your help badfish appreciate it.