syma x8w wont fly

si-james

si-james

New Member
Just got my x8w new from the box and it wont fly it barely lifts
,the props are correct and the batteries are charged,what might the problem be?? Any help would be massively appreciated
 
Yes,everything's is aesthetically how it should be its just like I'm not getting enough power from the motors??its brand new from the shop......
 
Well the only other thing I can suggest to to check the voltage of your battery with a meter fresh off the charger. Maybe your charger is faulty.
 
Did that,the batteries are fine,however I've inspected the gear cog and the 2 ccw motors were quite tight on the rod,thus not spinning at full potential so I've bored them out a little and re-greased,now waiting for batz to charge to trial it......i shall report back lol
 
I used a little bit of furniture polish to test it.(silicone based,due to lack of grease at the time) but it still wont take off,then I examined the board and found some corrosion so its going back to the factory for repairs im afraid to say.....
 
You must log in or register to reply here.
Back
Top