syma x8w problem need help

[EliRaN]

hi everyone i have the syma x8w and installed it currectly anf he flew a couple of time nice but now i start it synchronized it properly and it wont fly it start rotating the blades slowly and then stops... dont know why i resets the copter by holding the both axys to bottom left and its still doesnt fly
i uploaded a video to show the problem
please help me

 

[Mike H.]

Its possibly low voltage cut off...make sure the battery is fully charged and try again.

As much throttle as you had and it didnt even try to lift off indicates it probably didnt have enough power.

 

[Jackson]

The way it blinks after the props stop spinning looks like the low voltage warning. Do you have a multimeter? If not buy an inexpensive one (everyone should have one) and check the voltage of your batterries after charging they need to be greater than 8V.

 

[EliRaN]

i dont have one unfortionally ill buy one and let you know but i tried to fly it again and one of the motors stoped working so i realy thing he was the problem ... ill replace this motor and check the voltage hope it will work
and why it should be greater ther 8v if the battery is 7.4v ?

 

[Jackson]

greater ther 8v

8.4V fully charged.

 

[Mike H.]

Sometimes a gyro reset will get a motor working again..Get your battery fully charged and do a calibration with the quad before you conclude the motor is burned up.