Daan
New Member
Hello guys,
I am quite new to drones, and today I did a reparation on my Syma x20 for the first time. A motor had stopped working, so I had to solder a new one onto the circuit board. Now my drone is flying again, but it randomly stops working, as if it gets cut off the power supply, and falls out of the air.
It has little lights that would always start blinking to indicate it was low on juice, upon which you could land it, so that you wouldn't fully drain the battery. Now this does not happen anymore, so I'm afraid I might be frying my battery.
Does anyone now what the problem could be? Really all I did was take it apart, take off a motor, solder a new motor onto the circuit board, and reassemble it. Thanks in advance!
I am quite new to drones, and today I did a reparation on my Syma x20 for the first time. A motor had stopped working, so I had to solder a new one onto the circuit board. Now my drone is flying again, but it randomly stops working, as if it gets cut off the power supply, and falls out of the air.
It has little lights that would always start blinking to indicate it was low on juice, upon which you could land it, so that you wouldn't fully drain the battery. Now this does not happen anymore, so I'm afraid I might be frying my battery.
Does anyone now what the problem could be? Really all I did was take it apart, take off a motor, solder a new motor onto the circuit board, and reassemble it. Thanks in advance!
