Slight assover tea kettle rotation on BetaFlight receiver screen

tesla1980

tesla1980

Active Member
I have a X7 controller, BetaFlight F4 FC and a FrSky transmitter/receiver

When i go to the receiver screen the image of the drone it slowly pitching up and and over. I assume i need to trim out the pitch somehow, what is the way that is done. I was looking through all the setting and nothing seem blatantly obvious. Thanks !
 
I wouldn't rely too much on that image, it's the figures that really matter. Go into the receiver tab in Betaflight and look at your midpoint settings in channels 1 to 4 (AETR) which should be at 1500. If they are less or more, they need to be adjusted. This is done through your QX7
 
A couple of mine rotate slowly.
As long as the calibration is done AOK.
I recently bought a omnibus f3 mini & off the bat the gyro is flipped. It's the right way up but facing reverse, so you would think it just needs a 180° in config tab, but no it needed a flip over as well. First for me,aswell as a remap of a 4in1 esc. The board print was correct but the guts was wrong. All fixed easy though.
 
You must log in or register to reply here.
Back
Top