Repair Question, Please?

[Maggie]

I've had my first semi crash and I don't know what I'm supposed to do next because the crash affected my Front left (R) reversal blade. After the crash I replaced the blade in hopes that that would fix the fact that it was not rotating and after cleaning the gears, replacing the blade and reassembly the blade still will not rotate. Before replacing the blade the gear was sticking a bit and would not complete a rotation but now it spins again but not that easily or smoothly! Help, What do I do? Its gorgeous outside!!!!

It's an F-Series Super Scorpion 2.4Ghz with 6 axis gyro

 

[GJH105775]

WHat site did you get this from? Can you post the link, it may have some needed information.

 

[holtneil]

Hi Maggie does the motor spin if you remove the gear if not the coreless motor has gone and will need to be replaced

 

[Maggie]

No its not spinning

 

[Maggie]

I see so each one has its own motor

 

[holtneil]

Hi Maggie yes its a coreless its the small silver tube thats up side down , it has the small gear on the bottom of it this then drives the bigger white gear , this in turn ups the gearing to the prop, If you look at photo 4 you can see the red wire at the top then behind the motor is the blue wire , the coreless motors can be single or packs of 4 they are not a bad price you need to make sure you get the right one as the motor must spin in the right direction , if you can remove the top body off the quad to get to the board if your really lucky the motors may just plug into the board if not then they will need to be soldered to the board

 

[Maggie]

Youre are awesome Holtneil! Thank you so much. Can I contact you again if I have more trouble?

 

[holtneil]

Yes no problem I am always here at some point every day

 

[Maggie]

the board looks like this

 

[Maggie]

Should i assume that they are soldered?

 

[holtneil]

Yes they are so your need a very small tip soldering iron

 

[Maggie]

Gotcha!