Quad still wont take off properly.

[irishluck]

Okay so just to be clear so I dont mess up, take a + lead from the distribution board and attached it to the + side of the red headers and that is it?
Any thing I have to change in the setting on the KK?
What voltage will the buzzer go off and warn me?

 

[GJH105775]

Okay so just to be clear so I dont mess up, take a + lead from the distribution board and attached it to the + side of the red headers and that is it?
Any thing I have to change in the setting on the KK?
What voltage will the buzzer go off and warn me?

You then need to go into misc settings and turn alarm above 0.

 

[irishluck]

Awesome, Got that to work, and learned a valued lesson today.

Always check your prop nuts to make sure there tight lol

 

[GJH105775]

Awesome, Got that to work, and learned a valued lesson today.

Always check your prop nuts to make sure there tight lol

Hahahaha, triple check them if you must xD

 

[irishluck]

Ill post a video. Still landed on its landing gear after it rolled like 2 times lol

I get my new ESC's tomorrow so ill be installing them and gota run to the hardware store for some M5 nuts lol
Next upgrade will be my FPV system and also trying to get the quad to self hover properly.

 

[GJH105775]

Ill post a video. Still landed on its landing gear after it rolled like 2 times lol

I get my new ESC's tomorrow so ill be installing them and gota run to the hardware store for some M5 nuts lol
Next upgrade will be my FPV system and also trying to get the quad to self hover properly.

Hahaha, sounds good.

 

[irishluck]

Alright so i got my new ESC's yesterday. Got them from Readytoflyquads.com. Got the 30a fire red series ESC's with simonk.

Im wondering exactly how would i set my quad up to be able to hover. I have yet been able to get this to happen. And since i have a 6ch radio, can i somehow set a switch or something on the radio for a self hover mode?

 

[GJH105775]

Alright so i got my new ESC's yesterday. Got them from Readytoflyquads.com. Got the 30a fire red series ESC's with simonk.

Im wondering exactly how would i set my quad up to be able to hover. I have yet been able to get this to happen. And since i have a 6ch radio, can i somehow set a switch or something on the radio for a self hover mode?

Autolevel, if your using a KK, and yes, but you might have to tune it.

 

[irishluck]

K i looked on youtube on how to set it up and its on. Played with the setting a little but not yet hovering. The roll and pitch are working like they are suppose to from the self-level setting(its slow).

So guess i need to play with just a little more and figure out how to tune.