Please help

Loki

Loki

Member
Hi everyone I have a question just brought the taranis se carbon I was using a turnigy i6 that’s all setup on quadcopter with sbus receiver if I change out the receiver for the taranis sbus receiver and bind would I need to go into clean flight again to make it fly I ask as my computer has died and don’t want to replace yet hope this all makes sense as I’m quite new to diy quads the build is easy but still learning about setup and adjustments thanks a lot for your help thank you.
 
Technically speaking yes. But some times things are never that simple @ worst a board reset but you are screwed for that. Are you running Dshot = no esc calibration. Shame you not had smart audio setup before your PC went kuput.
 
Been thinking and Iv brought a frsky micro sbus receiver today to throw on my little qx95 so I can fly over Xmas and il replace my pc in new year probably the safest option if something goes wrong and it eats floor then only cheep to fix thanks for advice
 
You must log in or register to reply here.
Back
Top