Sammy_
New Member
Hi Everyone.
I'm just getting into the hobby and got my first FPV drone delivered yesterday.
Sadly I've already messed up before even getting a chance at flying.
I got the mana 285
gearbest
/multi-rotor-parts/pp_599156.html
I followed the instructions in the manual and flashed cleanflight 2.03. No probs. But I could not get RX enabled for UART 3 and the SBUS receiver setting just kept disappearing. I did something very stupid and disabled UART1 MST and now I can no longer connect or reflash. I tried full chip reset and set the correct manual baut rate but keep getting "no response from the bootloader, programming failed". No one seemed to have found a boot pin on this quad and the "recovery / lost communication" instructions mentioned one. I'm not sure what to do. Has anyone got any advice what I could try? I also tried flashing betaflight and get the same error.
Thanks for reading.
I'm just getting into the hobby and got my first FPV drone delivered yesterday.
Sadly I've already messed up before even getting a chance at flying.
I got the mana 285
gearbest
/multi-rotor-parts/pp_599156.html
I followed the instructions in the manual and flashed cleanflight 2.03. No probs. But I could not get RX enabled for UART 3 and the SBUS receiver setting just kept disappearing. I did something very stupid and disabled UART1 MST and now I can no longer connect or reflash. I tried full chip reset and set the correct manual baut rate but keep getting "no response from the bootloader, programming failed". No one seemed to have found a boot pin on this quad and the "recovery / lost communication" instructions mentioned one. I'm not sure what to do. Has anyone got any advice what I could try? I also tried flashing betaflight and get the same error.
Thanks for reading.