New to Drones help needed

[Ahab131]

Hi, I have a Wizard X220S which I have had problems with and nearly sorted now but I have lost the CLI information and would much appreciate if someone could do a screen dump to a text document so I could copy it. As I have lost all the led settings. Thanks in anticipation

 

[mozquito1]

Reflashing the to the previous firmware then back should sort it. Do a full wipe.

 

[Ahab131]

Thanks, I will give it a try

 

[mozquito1]

Back when I started the only things to change was the mid point to 1500.
Motor stop & ppm or pwm.
There was other stuff but I just changed them & the pids. I don't get it all but filters is the thing lately. I don't mess with cli now as it's all in the menus. DOS done my head in even though I was brought up on zx spectrum, commodore64, IBM.

 

[Ahab131]

I have also found that the motor's power up even tho I have motor stop enabled

 

[mozquito1]

In both cli and on the configuration tab.
Although you should only have to apply it in config.

 

[mozquito1]

Have you calibrated the esc's.