new quad version 4

Discussion in 'Build Logs' started by bugwalsh, May 27, 2017.

  1. bugwalsh

    bugwalsh Well-Known Member

    just finished my new quad (mark 4).
    its 400 x 350 mm with 10x4.5 props
    A2212/13T 1000kv motors
    16 mm dia carbon tube arms (ally tube clamps plastic motor mounts)
    flat ally body with foam covered wire legs.
    CC3D and fleshy fs-i6 transmitter fsi6a receiver (for mow)
    weight without battery 649g with 3000mAh s3 battery. 916g

    hopefully I will get to test her out tomorrow.

    then need a camera. [​IMG]:)
    [​IMG]
     
    mozquito1, RENOV8R and dragger201 like this.
  2. RENOV8R

    RENOV8R Well-Known Member

    Good luck, hope your first flight goes well!
     
  3. Jackson

    Jackson USA member at large

    FWIW I use the same motors with Carbon Nylon 1045 props. I have found that the black seem more brittle than the colors. I'm also a firm proponent of contrasting colors front to rear. Surprisingly I've also found the props be well balanced.
     
  4. bugwalsh

    bugwalsh Well-Known Member

    The props are just cheep plastic (still learning to fly the thing).
    As I get more experience I will prob look at maybe a octocopter so I can fit a better camera.
    but when I stop crashing I will get multi colour ones jus so I get the correct rotation . :)
     

Share This Page