New member propel skymaster 1540

B

buddy

Member
I have a propel sky master 1540 should there be much free play between the prop and the cone shaped capI find when I start the props I hear it pop the props are pushed up against the cone and make a clicking noise is this normal or should there be less free play between the prop and the bottom. I also find that after I get the props moving and take off then when I descend slowly and land I still have two props spinning very slow. There is not trim adjustment to compensate for this. Any help would be appreciated. I have done the calibration correctly . This drone has the camera as well
 
B

buddy

Member
I have looked at the eBay picture and also read the manual front to back
I trued calling propel and that’s a waste of time . I was hoping some one on the forum might have the same drone , I have seen them on eBay for 4 years
 
B

buddy

Member
Yes that video is the one I have. I wanted to know aboit the play I have in the props when I start the motors the push up against the prop cone and it looks like there is a bit of play between the travel as the prop is thrust up. I guess I need to find someone who has this drone. Thanks for your response
 
You must log in or register to reply here.
Top