Needing help with Flysky I6

Discussion in 'First Build' started by Kraken, Jan 16, 2018.

  1. Kraken

    Kraken New Member

    So I recently bought a half built quad that had a Dx5e reciever originally now instead of buying another remote I purchased a Flysky I6 as this is my first for quad not my first time flying but my first time diving in anyways I'm lost at the part where the board connects to the new receiver the old AR610 has different inputs then the one that came with the flysky it just has channels instead of what the 610 had can anyone help me out here where or how to connect the wires
     
  2. Jackson

    Jackson USA member at large

    To what from what? What RX do you have? You have to provide some details.
     
  3. Kraken

    Kraken New Member

    Hey, sorry about that ! I appreciate your help from the board to the receiver this is what it looked like before I switched this one with the flysky receiver the RX I'm not sure of as I'm still new to building them if need be I can upload a picture of the other receiver
     

    Attached Files:

  4. Jackson

    Jackson USA member at large

    Well this would be the corresponding FlySky RX channels for the older iA6 and iA6B RXs.

    [​IMG]

    I see no reason for the last one BND/DAT, leave if off. You will probably have to go into the radio's menu and assign switches to your AUX channels. It's impossible to tell how it is setup now. ch6 could be set to a 2 position for arming and ch5 could be the 3 position switch used for your flight modes.
     
  5. Kraken

    Kraken New Member

    Ohh okay! I see what your saying I get it I was lost at the whole plug in but now it makes sense hey I appreciate your help in the matter been stuck at this spot for a couple days now... Thanks!
     

Share This Page