Naze32 not arming.

[DrDiff]

Ok FlySky TH9X tx and FlySky rx. Afro Naze32 With Clear Flight 1.8.1

If I plug the esc into ch 3, the esc works and the motor spins. When the ESC's are plugged into the Naze, they chime when you plug in the battery. And if plugged into the computer the ESCs all spin their motors in synch.

Clear flight shows the tx sending signals to the rx but, the system won't arm. The low end throttle is coming out of the rx at 1093, low end of rudder is 1093 and 1900 high end. I can not get the system to arm.

Ultimately I want to get the system to arm on aux 1.

But for now, I can't get it to arm.

 

[GJH105775]

Casn you view the raw inputs on the board?

 

[DrDiff]

Yes when I switch to receiver mode it shows the throttle moving through its range...

 

[GJH105775]

Did it just start this, or is this a new problem after it was arming?

 

[GJH105775]

 

[DrDiff]

First time setting it up. New board new quad.

 

[GJH105775]

And you are in fact arming like the picture says then correct? It could easily be something like endpoints and middle points. You need it right on the throttle and yaw.

 

[DrDiff]

When hooked to the Clean Flight, the bottom end of the throttle is 1093. Rudder low end is also 1093 high end rudder is 1900. Mid point is 1501 - 1500.

 

[DrDiff]

What is the correct arming procedure throttle and rudder bottom right for 5 seconds to arm?

 

[GJH105775]

Providing nothing is reversed, then yes. Soetimes you may need to reverse a channell. Try bottom left to see if that is the case for the yaw.

 

[DrDiff]

On the configuration page of Clear Fligh . I set the min throttle to 1200.

Now I have the tx making the throttle function.