Naze32 issue

[Enis Bukalo]

Hello. So i am completely new to this hobby. I currently own a couple of HPI and Traxxas trucks but never a multi rotor. I set up my quadcopter with the Naze32 and I bought a flysky T6 transmitter that comes with its own receiver. I plugged it all in and hooked it all up and connected it to Cleanflight. The receiver is getting signals based off of cleanflight, but when i unplug it from the computer, the motors dont react at all. Also, when i manually test the motors, only motors 1 and 2 spin, 3 and 4 will not. Currently connected to a 2S lipo just for testing. Any help would be great thanks.

 

[ringolong]

Is it setup as a quad in the settings in cleanflight?

Also, do all motors spin while testing the motors in cleanflight?

 

[Enis Bukalo]

No only motors 1 and 2 spin. I take out the motors plugged into 3 and 4, place them into 1 and 2, they spin also but 3 and 4 still don't spin. and yes it is setup as quadX

 

[ringolong]

Do they all spin while testing the motors in cleanflight?

Sounds like the motors are ok, but need to make sure the escs are ok before finding the culprit.

 

[Enis Bukalo]

I switched the motors from 3 & 4 to 1 & 2, (escs are soldered to motors) and they spun up. but just 1 & 2. all 4 spin from cleanflight, but only if they are plugged into 1 or 2, 3 and 4 don't respond.

 

[ringolong]

Sounds like it could be a bad board. Is it a new one?

I don't think calibration is the issue, but did you calibrate the escs?

You could save your settings, and try flashing the board.

 

[Enis Bukalo]

Oh poop thats what i figured, it was the board from HobbyKing, funfly version i guess. I just ordered the whole thing with GPS and BARO, hopefully it works lol thanks.