Naze32 Clean Flight 1.8.1 Motor syncronization issue

[DrDiff]

I am having motor syncronization issues with my Naze32 Running Clean Flight 1.8.1.

I have individually went through the calibration proces with each ESC and the TX/RX.

I then pluged everything into the Naze and then went to the motor page of CF and checked the motor test mode box. I then proceded to re-calibrated the ESCs all toghether with the Master Slider. At this point Clean Flight shows all 4 motors syncronizing and all come on and off at the same time.

Then I un-check the box and use the TX (FlySky TH9X and Flysky RX) and CF says that the motors are now out of syncronization.

Is this a TX setup problem, or is it a Motor syncroization problem?

On the RX tab of clean flight all four channels are centered at 1500-1501

Thanks for the help!

 

[DrDiff]

It came to me last night as I was falling asleep. I am in the middle of the build. I had just finished soldering the pins to the board. It is not mounted on the chassis. The USB cable is not allowing it to lie flat and the Naze is in angle mode. It is trying to self level.