Motors won't start

[Niacuadala]

Hi everyone, so I had this quadcopter for a long time and now with the quarantine I had some time to ensable it. I have a naza-m that I was able to connect to my PC. It is upgraded with the last firmware (4.02) and I was able to calibrate, test motors, everything. The TX is a Turnigy 9X that I also managed to configure.

The issue I have now is that the motors won't start. The naza keeps blinking twice in yellow. According to the manual,
http://dl.djicdn.com/downloads/nazam-v2/en/NAZA-M_Quick_Start_Guide_v1.24_en.pdf
It means that sticks are not at center, but as said, I have calibrated all and sticks are centered.

If I switch to manual mode, led stops blinking but cannot start motors anyway.

I am out of ideas, any help very much appreciated.

 

[holtneil]

Check to make sure it is seeing the stick in the middle on the pc , you may have to go into the transmitter to adjust the travel so they are showing middle

 

[Dugdog47]

Could also be the min throttle settings on betaflight/bl heli. Some flight controllers are picky on that.

 

[Niacuadala]

Hi both, thanks for your answers. I did as you told me but no luck. I have done a video with my current status:

Still not able to start motors.

Thanks.