Lumenier QAV-XS

Discussion in 'Build Logs' started by RENOV8R, Feb 7, 2018.

  1. roger jones

    roger jones Well-Known Member

    I was thinking that I assume there is some hidden soldering?

    Or is it plug and play?
     
  2. mozquito1

    mozquito1 Well-Known Member

    Nah atleast 15 points to solder. 12 motor wires & the rx, then a couple more for for the vtx & lipo connector.
     
    RENOV8R and Spork like this.
  3. Spork

    Spork There is no spoon

    If you look at his third pic you can see some evidence of soldering. The rest are neatly hidden away - either under the board and maybe in those braided cable covers.
     
    mozquito1 and roger jones like this.
  4. mozquito1

    mozquito1 Well-Known Member

    Oh cowboy:p
     
    Spork likes this.
  5. roger jones

    roger jones Well-Known Member

    Ah thanks, I had not thought about them being covers. I like that idea.
     
    Spork likes this.
  6. mozquito1

    mozquito1 Well-Known Member

    Jacksons digging for go pro mounts,
    I knows it. :cool:
     
  7. RENOV8R

    RENOV8R Well-Known Member

    You are correct. 12 for motors soldered to the underside of the fc, 3 for rx and 4 for vtx /camera ground and signal in and out of the fc for OSD
     
  8. mozquito1

    mozquito1 Well-Known Member

    Maybe not :(
     
  9. mozquito1

    mozquito1 Well-Known Member

    Any more pictures of the finished quad.
    I just orderd parts for a new quad.
    DSC07600_crop_550x321.jpg
    The motor I want to try are only cheap RJX Hobby 2205 2600kv. £8 each.
    I intend putting emax on it eventually.
    I just want to try the motors for cheaper builds. They come yesterday & seem decent. Windings OK, wires OK, strong magnets.. When all the bits are here I will do a thread. Does anybody know if you can block a thread till you have finished writing.
     

Share This Page