Lowest RSSI value in configuration setup and google

[koklimabc]

I've recently bind my both R9 slim + OTA receiver on my quad, one for Telemetry ON and one for Telemetry OFF (Redundancy built).

In CLI, I do make liked this,

set serialrx_halfduplex = OFF

set serialrx_inverted = OFF

get tlm

set tlm_halfduplex = OFF

set rssi_scale = 200

T18 Jumper settings

(Bind)

Ch 1 to 8 - Telemetry ON

Ch 1 to 8 - Telemetry OFF

(Inputs)

Set in Channel 9

Source = RSSI

Scale = 100 dB

(Mixes)

Set In channel 9

Offset = -100

(Telemetry)

Delete all sensors

Discover new sensors

Only appear with two lines but no more,

1. RxBt 4.9V *

2. RSSI 100 *

(Under Betaflight's Receiver Tab)

Aux 12 - working

My Question Here

1. It appear my setup (Under Configuration Tab) just showing 20 to 21 % only, It also reflect the same when

i view it under my FPVgoogle. How to fix it?

2. Is that possible to bind as Ch 9 to 16 (Telemetry ON/OFF) since AUX 12 is working under this range ?

3. My Controller's Telemetry just shown two lines of result (RxBt, RSSI) after done with "delete & discover a

new sensors", why?

 

[Dugdog47]

I don't know about the r9s but the xm+ rssi has to be set to channel 12.

 

[koklimabc]

I don't know about the r9s but the xm+ rssi has to be set to channel 12.

Yes, Since i'd set Channel 9 under my controller for Inputs and Mixes, It will became "9" + 3 equal to 12 as AUX under betaflight.

Why RSSI readings keep showing lower than actual to 20% after I've set to RSSI_SCALE to 200?

 

[Dugdog47]

That I don't know