kk2.1.5 "no yaw input" "no motor layout"

[irishluck]

Pretty much what the title says.

I installed new firmware last night. the 1.19S1 version.
Everything working except the main screen shows error and says "no motor layout"

I just figured out the motor layout.

But still says no yaw input

 

[holtneil]

HI mate steveis1.8s1pro is for the kk2.1.5 the 1.9 is for the acro board or if you have a faulty acc , reflash with 1.8s1pro

 

[irishluck]

Ok will cgeck bk in a few with update

 

[irishluck]

I dont see that one on the flashing software. I see the 1.18s1 and the 1.9s1

 

[irishluck]

I just reflashed it with the 1.18s1 and it still says no yaw input and no roll input....

 

[GJH105775]

I just reflashed it with the 1.18s1 and it still says no yaw input and no roll input....

Turn the transmitter on BEFORE you turn the quadcopter on, this is a very common problem users have with the KK, and is done to force people to turn tx on before the quad, as this helps to prevent interference from taking control of the craft..

 

[irishluck]

K i did that and now it says safe.

Now what? How do i actually start it now and fly it?

 

[GJH105775]

Go into settings and set self-level to stick

 

[GJH105775]

Before you try to arm it check in the reciever test that all values are trimmed to 0, and that they don't need to be reversed, if I remember right one will usually need to be reversed.


To arm it is right stick down and to the right, and disarm it is to the left, turning autolevel you move the left stick either right (or left i don't remember) while arming or disarming (either will work, I prefer to do it while disarming to see that it is in fact on)

 

[GJH105775]

Use these instructions for tuning it.

 

[irishluck]

Well it defiantly comes on lol

My throttle on the receiver test is showing around 50.

How do I change that to 0?

 

[GJH105775]

What transmitter are you using?

Just look in your manual for trimming. Does eveything show the right direction? (like rudder left and right)

 

[irishluck]

Everything shows the right direction yes.

Im using a skysport4 Futaba. I dont have a manual for it.

 

[irishluck]

I have the trim set as far as I can down. The throttle is still at 33 on the FC

 

[GJH105775]

Do you have the throttle stick all the way down?

 

[Jackson]

Everything shows the right direction yes.

Im using a skysport4 Futaba. I dont have a manual for it.

http://manuals.hobbico.com/fut/4vf-manual.pdf

Pretty weird, rather sparse.

 

[irishluck]

Do you have the throttle stick all the way down?

Actually confused bout that.

The throttle is working for the right thumb stick which is dspring loaded.
The left stick seems to control whick way it goes

 

[irishluck]

The servo wires are backwarrds arent they

 

[irishluck]

Okay I got the throttle to work properly.
The throttle stick is controlling the right thing now.

Issue I am having now is that when I apply the throttle very slowly only the #! motor starts and once i give it a little more the #2 motor and then the last 2 motors came on.

 

[Jackson]

Try this.