Is my flight controller brushed or brushless

[Jasonlukecurtis]

I was sent a replacement because my alien flight board was a dud and i was sent the nz32 lite (comes under many other names)
But i don't believe this new board is for brushed motors or my mini brushed quad. Can anyone help me in identifying weather it's brushed or brushless.
If i connect everything up (board and receiver) getting power if i put a motor on the pins sticking out the motor just spins also the pins are as labeled motor 1 GND and VCC i would imagine the motor 1 pin is for a signal wire?

 

[GJH105775]

I was sent a replacement because my alien flight board was a dud and i was sent the nz32 lite (comes under many other names)
But i don't believe this new board is for brushed motors or my mini brushed quad. Can anyone help me in identifying weather it's brushed or brushless.
If i connect everything up (board and receiver) getting power if i put a motor on the pins sticking out the motor just spins also the pins are as labeled motor 1 GND and VCC i would imagine the motor 1 pin is for a signal wire?

Naza 32 is for brushless quads for sure. I'd message them about it.


The pwm outputs are also a giveaway, be sure to mention that.

 

[Jasonlukecurtis]

I knew that had sent me the wrong board. Hopefully they will sort something out so i can finally get my drone in the air. Thanks very much. I finally have an answer to my question