Jakerock
Member
Hello all,
First timer here...
I have a H107C+ and its yaw is wandering, even when trim is set.
I want to try the "Stick Calibration" in the manual but I cannot get it to work.
Supposed to put both sticks in upper left corner, turn on, wiggle sticks, and then...
..."hold down any trim until the LED on the transmitter blinks red..."
1. There is no LED on an H107C+ transmitter
2. I dont think it did anything...didnt beep.
Anyone have insight?
If I could just trim that yaw steady....
Thanks, J
First timer here...
I have a H107C+ and its yaw is wandering, even when trim is set.
I want to try the "Stick Calibration" in the manual but I cannot get it to work.
Supposed to put both sticks in upper left corner, turn on, wiggle sticks, and then...
..."hold down any trim until the LED on the transmitter blinks red..."
1. There is no LED on an H107C+ transmitter
2. I dont think it did anything...didnt beep.
Anyone have insight?
If I could just trim that yaw steady....
Thanks, J
Last edited: