How do I flash this contoller?

[AxeGrinder]

I set my QC project aside a couple of years ago, after I cashed it 1st flight out... Finally, I'm working on it again, but can't upload the KKmulticopter software to the controller.

Attached is a photo of the KK controller, I forgot the exact model, but it is KK2.1 perhaps? I keep getting "Error during updating the fuses ", I suspect that this is due to not using the correct software version.

Any info would be fab!

 

[Jackson]

http://www.pyramidmodels.com/shop/p..._kk_multicopter_control_board_blackboard_v5_5

https://www.rcgroups.com/forums/showthread.php?t=2068825

 

[RENOV8R]

I say ditch that dinosaur and get with the times! Didn't know they made a FC where you adjusted your gains with a screwdriver

 

[AxeGrinder]

http://www.pyramidmodels.com/shop/p..._kk_multicopter_control_board_blackboard_v5_5

https://www.rcgroups.com/forums/showthread.php?t=2068825

Thanks, but that is a Black Board, I'll look through what says tho. Cant read the chip either, haha

 

[AxeGrinder]

I say ditch that dinosaur and get with the times! Didn't know they made a FC where you adjusted your gains with a screwdriver

I do know that option, but cash is short, and I'd like to use this FC for a 3 axis gimble, somewhere down the road, so I need to get info anyway.

 

[AxeGrinder]

I am certain this is the same item I have, however, the software so easy to find under the "Files" tab lower down, tho there is plenty of info about the board.
https://hobbyking.com/en_us/hobbyking-multi-rotor-control-board-v2-1-atmega168pa.html

 

[RENOV8R]

I do know that option, but cash is short, and I'd like to use this FC for a 3 axis gimble, somewhere down the road, so I need to get info anyway.

I hear you, wish I had an unlimited supply of cash! Just an FYI, unless you're doing a DIY gimbal you won't need the FC. 3-axis gimbals are now a simple single wire connection to SBus out of your receiver to control all functions.