Help with baseflight and naze 32

1

1251452

Well-Known Member
It's not the numbers that's important, how is the travel of your throttle and rudder? Did you try assigning a switch to the arm mode?
 
ringolong

ringolong

Well-Known Member
Do those channels move when powered up and the radio is on in bf? (Do not do this with the props on)
 
ringolong

ringolong

Well-Known Member
P1050011-e1454689550848.jpg
 
fiestafrog

fiestafrog

Well-Known Member
In the video I'm watching, he sets up an aux switch. He already has the switch hooked up to respond in the video and I don't know how he got there. How do you link the copter to the auxiliary switch?
 
ringolong

ringolong

Well-Known Member
If it is not arming then your radio is not calibrated to the naze. Calibrate both of them.

I have my arm setup to a switch also for my naze too.

You have to map the channel on the radio to one of the aux channels, and the actual switch you want to use for it. Next, you have to add it to your map in bf.

Click on the cli tab and type in map and hit enter. This will show you your current map on the naze. You can change the aux position if you need to here.
 
fiestafrog

fiestafrog

Well-Known Member
I watched for a half hour then he says "I'm going to assume that you know how to set up the radio so I'm going to skip that part " lol uggh!
 
You must log in or register to reply here.
Top