Help needed please.

Discussion in 'Introductions' started by KGB69, Apr 19, 2018.

  1. KGB69

    KGB69 New Member

    Hello all members
    My name is Kevin.
    I am a totally new to Rc Drones But used to fly 60 size Helicopters and scale.
    I am having some problems with my build my Acro Naze 32 is not powering up my fs-X6B receiver.
    I have done the bind and all went well. When plugged into Cleanflight and Battery or Battery only its not lighting the LED as no power ? everything is set to PPM so only have Ground and positive and pin 1 on the board.
    Any advice welcome
     
  2. RENOV8R

    RENOV8R Well-Known Member

    Did you make sure that the pin you connected to on the Naze was supplying 5 volts? What ESCs are you using and how are they connected? A photo of your connections would be helpful
     
  3. KGB69

    KGB69 New Member

    Thank you for your time .yes I have a 5 volt output running it on pins 6. and used that output to bind transmitter to receiver. Will pop a picture on 2moz, not sure on ESC`s but have had all four working.
     

Share This Page