help again.:(

[bugwalsh]

Hi all,
Im back again needing help,

I have had a slight mishap with my quad. I went to pick the thing up and diss lodged one of the control cables from a ESC. to the cc3d (all 3 Power/ 0 volt / and signal) while the battery was connected and unit armed.

now the motor won't turn it just pulses (beeps) have i stuffed the ESC or the motor or both


thanks .

 

[GJH105775]

Can you provide a picture? Sounds like you just need to plug them back in or push the ends back into the connector.

 

[bugwalsh]

Hi I've tried to reconnecting the plug and all i get is a pulsing beep about 1 second on and one second off.
i have connected it to the receiver and still the same, other 3 are working fine on t cc3d and receiver

 

[bugwalsh]

and in my best Victor meldrew voice
I DON'T BELIEVE IT the ESC and motor have just started working again

sadly i will have to wait to test it till tomorrow as the wife has band me flying it in the house since i wiped out halve the xmas decorations and the tree

 

[GJH105775]

and in my best Victor meldrew voice
I DON'T BELIEVE IT the ESC and motor have just started working again

sadly i will have to wait to test it till tomorrow as the wife has band me flying it in the house since i wiped out halve the xmas decorations and the tree

Hahahaahaha. Sounds good.