Jadams453
Well-Known Member
So I finished installing the DYS F4 on my main, and favorite quad last night. Hooked it up to betaflight to flash the latest version of firmware just in case, then set everything up in configuration, setup osd etc..I spun up all 4 motors to make sure they were good (and all 4 did just fine.) Once I setup my flight modes and arm switch and saved everything all that was left was a test flight..which is where my problem presented itself. When I armed the quad only the 2 back motors spin, the front 2 (motors 2 & 4 I believe) wouldn't do anything, although they spin up just fine when commanded to in betaflight. Has anyone had or heard of an issue like this, or any suggestions as to what I should check? Any help would be greatly appreciated.