I have just built my first quad - a Flamewheel F450. I bought the ST32 2 axis gimbal after seeing videos on the simple connectivity. When mine arrived, the circuit board has been changed and I can't find any videos on the one I have. Could anyone please tell me which pin I need to connect to the Naza Lite? I have attached pictures of the gimbal. Thank you.
Goodluckbuy Gimbal and Naza Lite
- Thread starter Kevalino
- Start date
ringolong
Well-Known Member
It's on the RC2 port.
Therefore a typical connection (using the RC2 port as example) will look like this:
Resource:
http://www.olliw.eu/storm32bgc-wiki/Configure_the_RC_Input
Therefore a typical connection (using the RC2 port as example) will look like this:
- One of the receiver's GND pin is connected to RC2-GND, which is the pin next to the label (see image below, the black GND cable is the top most)
- The receiver's channel 3 signal pin is connected to RC2-0 (green cable below) used for pitch
- The receiver's channel 4 signal pin is connected to RC2-1 (white cable below) used for yaw
Resource:
http://www.olliw.eu/storm32bgc-wiki/Configure_the_RC_Input
Jackson
USA member at large
Actually it's the first generation you have, V1.0.
Ah - ok that will be why all the info I can find is different to mine. Still trying to figure it out!
Jackson
USA member at large
Well what happens when you simply power it up (red/black leads), does it initialize and then stabilize?