Alex96
New Member
I purchased a FlySky FS-i6 transmitter and FS-iA6B receiver. After binding the two, I see a solid red light on the receiver when both are powered on, and I can view the battery status on the transmitter, so I’m confident the binding was successful.
Next, I connected the receiver to my flight controller using the provided cable, plugging it into the iBus pins (covering channel 5, channel 6, and VCC).
In Betaflight, I enabled Serial RX on UART 2 and selected "Serial-based" with iBus in the configuration tab.
At this stage, I expected to see my transmitter's inputs reflected in Betaflight, but no changes are being detected.
Next, I connected the receiver to my flight controller using the provided cable, plugging it into the iBus pins (covering channel 5, channel 6, and VCC).
In Betaflight, I enabled Serial RX on UART 2 and selected "Serial-based" with iBus in the configuration tab.
At this stage, I expected to see my transmitter's inputs reflected in Betaflight, but no changes are being detected.