flight controller beeping and blinking constantly

Discussion in 'First Build' started by Alex2000, May 14, 2018.

  1. Alex2000

    Alex2000 New Member

    I just replaced one of the esc's on my drone and now when i power on the drone, it constantly beeps and the flight controller is blinking red as well. If someone could help me figure this out it would be greatly appreciated.
     
  2. holtneil

    holtneil Well-Known Member Moderator

    Hi can you give the guys more info what quad is it ?
    Is it the same make of ESC that it came with ?
     
  3. Alex2000

    Alex2000 New Member

    Yeah the quad is a arris c250, and yes it is the same ESC that came with it. I got the beeping to stop by resetting the quad but now I’m having trouble pairing the flysky radio to the receiver.
     
  4. GJH105775

    GJH105775 Avid Linux User, and U.S. Air Force 1C6 Moderator

    Do your new ESCs have a BEC (5v output)? Did everything work before the ESCs had to be replaced?
     
  5. RENOV8R

    RENOV8R Well-Known Member

    Blinking red LED on your flight controller typically indicates that it's not getting a signal from the receiver.
     
    GJH105775 likes this.
  6. mozquito1

    mozquito1 Well-Known Member

    What rx do you have.? It can be a bit tricky having only 2 handso_O
    Normally you have to press the bind button on Tx then press the other button on rx & apply the power. The tx will then confirm it is bound.
    If you want help with Aux switches, just ask. :cool:
     
  7. mozquito1

    mozquito1 Well-Known Member

    I did have an i6 but recently got the evolution.but both basically the same.
     

Share This Page