First tiny whoop build, drifts and needs to be bind constantly

[Icerook]

Beebrain flashed betaflight, dx6, brand new but for some reason I had to adjust a few things

Basically it's flying, angle mode, but it doesn't feel like the blade inductrix as in smooth flying so much, but any help with the listing would be great, the trim is too weak to correct much

I know this is clown shoes to most of you but anyone with a spectrum and a beebrain tiny whoop wanna give new advice I'm ALL ears!

 

[GJH105775]

Beebrain flashed betaflight, dx6, brand new but for some reason I had to adjust a few things

Basically it's flying, angle mode, but it doesn't feel like the blade inductrix as in smooth flying so much, but any help with the listing would be great, the trim is too weak to correct much

I know this is clown shoes to most of you but anyone with a spectrum and a beebrain tiny whoop wanna give new advice I'm ALL ears!

Sounds like PIDs for drifting, though the need to be rebound causes concern for the receiver too. Certainly odd. Does the drift get worse over time, or does it correct and start drifting the opposite direction? Are the receiver and flight controller combined to a single board?

 

[Icerook]

I wasn't waiting long enough to bind, I have two brand new dx6s so I've been comparing

But the drifting yes I'm sure it's the pids any suggestions for a beebrain?

 

[GJH105775]

Found a video that might help

BTW, it still makes sense at 1.5x speed