Now that I decided to build my first quad (no previous experience in RC, only in building custom computers) I quickly became familiar with the swamp that is availability of products and amount of shops there are.
Can you guys recommend some of the most reliable shops based in Europe?
Motivation of the build: fun in building, learning to fly, being able to maintain and fix my quad.
Budget: <500 Euro (including all the tools, RX/TX, FPV)
Now on to the actual build (shows the two shops im considering, to keep shipping cost down):
Frame: ZMR250 Carbon
FC: Naze 32 Acro
PDB: Matek PDB with 12V and 5V
ESC: SimonK 12A
Motors: noname 1804 2400kV (3x CCW, 3xCW, 1 spare each)
Transmitter/Receiver: FlySky fs i6 (with ia6 receiver)
Battery: tattu 1300 mAh45C (2x)
Charger: SkyRC e3 lipo 2-3s balance charger
Battery alert: Battery Monitor/Alarm
Props: 5030 nonames
FPV:
Camera: 1/3 Inch CMOS (PAL)
Transmitter: ET25R 5.8G 40CH 25mW
Goggles: Still undecided
Antenna Cheap Circular Polarised RP-SMA off ebay
Utilites:
Nylon Standoffs
Hook&Loop Strap
Double sided tap foam
XT60 Connector pack
12AWG Wire (Red / Black)
Soldering kit
Toolkit
Any Input is much appreciated.
As I know from helping people out with watercooling, things can get quite overwhelming with the amount of choices out there are. That's why I think it's crucial to get the insight of experienced pilots and mechanics like you guys.
I hope to get some feedback, maybe I should consider different batteries, motors, ESCs etc. or maybe I have an incompatibility somewhere, or even get a Kit.
Can you guys recommend some of the most reliable shops based in Europe?
Motivation of the build: fun in building, learning to fly, being able to maintain and fix my quad.
Budget: <500 Euro (including all the tools, RX/TX, FPV)
Now on to the actual build (shows the two shops im considering, to keep shipping cost down):
Frame: ZMR250 Carbon
FC: Naze 32 Acro
PDB: Matek PDB with 12V and 5V
ESC: SimonK 12A
Motors: noname 1804 2400kV (3x CCW, 3xCW, 1 spare each)
Transmitter/Receiver: FlySky fs i6 (with ia6 receiver)
Battery: tattu 1300 mAh45C (2x)
Charger: SkyRC e3 lipo 2-3s balance charger
Battery alert: Battery Monitor/Alarm
Props: 5030 nonames
FPV:
Camera: 1/3 Inch CMOS (PAL)
Transmitter: ET25R 5.8G 40CH 25mW
Goggles: Still undecided
Antenna Cheap Circular Polarised RP-SMA off ebay
Utilites:
Nylon Standoffs
Hook&Loop Strap
Double sided tap foam
XT60 Connector pack
12AWG Wire (Red / Black)
Soldering kit
Toolkit
Any Input is much appreciated.
As I know from helping people out with watercooling, things can get quite overwhelming with the amount of choices out there are. That's why I think it's crucial to get the insight of experienced pilots and mechanics like you guys.
I hope to get some feedback, maybe I should consider different batteries, motors, ESCs etc. or maybe I have an incompatibility somewhere, or even get a Kit.